SignWarehouse.com Enduracut Guía de usuario descargar pdf (Pagina 6)

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020

•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834

To properly abort a job while printing you should ﬁrst disconnect the USB cable

from the back of the printer. Leave the USB cable unplugged, right-click on the job

in the Queue and select Abort. Now it is safe to plug the USB cable back into the

printer.

To resume printing, examine the Queue drop down menu and select Manage

Queues. Make certain that your USB port has not been updated since you un-

plugged the USB cable. Close the Manage Queue dialog box and you are now

ready to resume printing.

Note: If you are going to print the same ﬁle you will need to right-click and clear

the error before printing.

To remove your roll prints, press the roll

media button to feed the media forward,

then cut off your printed images straight

across the media at the cutting guideline.

1.16

Pressing the Roll media button to advance the media pauses the printer. To resume

printing, press the roll media button again to return the media to printing

position. If The printer will remain paused and will not accept further commands

from the RIP software until the media is returned to the print position.

If you are ﬁnished printing and want to remove the roll, press the roll media button

for three seconds to feed the media backwards and out of the printer. If it

does not feed all the way out, press the roll media button again.

Removing the media will cause the amber Trash button to light. Printing will not re-

sume until this button is pressed to remove the ‘out of media’ error. Press the trash

button to clear this light. The trash can button is used for clearing paper

feed errors (ejecting vinyl out of the back of the printer, or printing without vinyl

loaded in the printer).

Removing Prints and Unloading Roll Media

1.17

Aborting a Print Job

1 2 3 4 5 6 7 8 9 10 11 ... 80 81

Sin comentarios

SignWarehouse.com Enduracut Guía de usuario Pagina 6