SignWarehouse.com Enduracut Guía de usuario descargar pdf (Pagina 5)

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020

•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834

Open the carriage cover and install the ink

cartridges. The correct order, from left to

right (when facing the printer) is:

Yellow, Magenta, Cyan, Black, Black, Cyan,

Magenta, Yellow.

You will see an error light if the inks are not

installed correctly.

After the cartridges are installed and pressed down fully close the

carriage cover and hit the ink drop button on the grey keypad again. Once the

green light over the power button stops ﬂashing the ink charge has ﬁnished.

1.11

1.12

Installing the Media Roll

Place the roll on the roll holders. If looking at

the back of the printer the unﬁxed side of the

roller (with the yellow knob) should be placed

in the right hand slot.

1.13

Feed the end of the media into the roll feed-

er. The media should go directly under the

little white rollers you see in the slot. Guide

the media into the slot and hold it for a few

seconds until the printer feeds it in automati-

cally.

1.14

Open the Plexiglas cover and look into the printer to make sure the media is feed-

ing straight. The media must feed straight so the printer can properly identify the

edge of it. Because of variation in media width, it is not expected that the edges

will be evenly spaced from the sides, but rather that they will run parallel.

1.15

1 2 3 4 5 6 7 8 9 10 ... 80 81

Sin comentarios

SignWarehouse.com Enduracut Guía de usuario Pagina 5