SignWarehouse.com Enduracut Guía de usuario descargar pdf (Pagina 31)

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020

•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834

Open the JetCUT Print

Only queue. Go to

Devices>Print Test Page

and select the nozzle

check ﬁle (Nozzle_

Check_19.ps) to print.

Select the Default print

mode to print the nozzle

check ﬁle.

Note: The nozzle check ﬁle can only be printed from a Print only Queue. Setup a

Print Only Queue for your print jobs and send the nozzle check from there. Trying

to print a nozzle check from a Print and Cut queue will result in an error.

If the nozzle check is unsatisfactory, indicating non-printing or clogged nozzles...

1. Run a single Head Clean through the Device Properties in the Queue.

2. If step 1 does not solve the issue, run two more cleaning cycles, then print

another nozzle check. The pattern should be clear and complete.

3. If ﬁve or more repeated cleanings do not produce a clear complete nozzle check,

examine the cartridges and make sure they are properly seated in the carriage, that

the yellow seals have been removed, and that the breather holes are not covered.

10: Nozzle Check

10.1

10.2

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 80 81

Sin comentarios

SignWarehouse.com Enduracut Guía de usuario Pagina 31